12.18.06.NI.ECU.Measurement.and.Calibration.Toolkit.v2.0.1.ISO-T Setup Free
Download ===> https://geags.com/2tw7kJ
Title: How to Use NI ECU Measurement and Calibration Toolkit v2.0.1 ISO-T for Automotive Testing
Article:
If you are looking for a software tool that can help you measure and calibrate electronic control units (ECUs) for automotive applications, you might want to check out NI ECU Measurement and Calibration Toolkit v2.0.1 ISO-T. This toolkit is a collection of software drivers and utilities that enable you to communicate with ECUs using industry-standard protocols such as XCP, CCP, and KWP2000.
In this article, we will show you how to install and use this toolkit for ECU testing and development. You will learn how to:
Connect to an ECU using a supported hardware interface
Configure measurement and calibration parameters using an A2L file
Acquire ECU data and monitor ECU status using NI LabVIEW or NI VeriStand
Modify ECU variables and flash ECU memory using NI Calibration Executive
By the end of this article, you will be able to use NI ECU Measurement and Calibration Toolkit v2.0.1 ISO-T to perform various tasks related to ECU measurement and calibration.
What is NI ECU Measurement and Calibration Toolkit v2.0.1 ISO-T
NI ECU Measurement and Calibration Toolkit v2.0.1 ISO-T is a software tool that enables you to communicate with ECUs using industry-standard protocols such as XCP, CCP, and KWP2000. You can use this toolkit to perform tasks such as:
Reading and writing ECU memory
Measuring ECU signals
Calibrating ECU parameters
Flashing ECU firmware
Diagnosing ECU faults
This toolkit supports various hardware interfaces that can connect to ECUs via CAN, LIN, or Ethernet networks. Some of the supported hardware interfaces are:
NI USB-8502 CAN/LIN Interface Device
NI USB-8473 High-Speed CAN Interface Device
NI PXI-8513 High-Speed/FD CAN Interface Module
NI PXIe-8520 Ethernet Interface Module
This toolkit also integrates with various software applications that can help you create, execute, and automate ECU test scenarios. Some of the supported software applications are:
NI LabVIEW: a graphical programming environment that allows you to create custom applications for ECU testing and development.
NI VeriStand: a real-time testing platform that allows you to configure, run, and monitor ECU test systems.
NI Calibration Executive: a calibration management tool that allows you to modify ECU variables and flash ECU memory.
How to Install NI ECU Measurement and Calibration Toolkit v2.0.1 ISO-T
To install NI ECU Measurement and Calibration Toolkit v2.0.1 ISO-T, you need to have the following prerequisites:
A Windows PC with an available USB port or a PXI chassis with an available PXI slot.
A supported hardware interface that can connect to your ECU via CAN, LIN, or Ethernet.
An A2L file that describes the measurement and calibration parameters of your ECU.
A license for NI ECU Measurement and Calibration Toolkit v2.0.1 ISO-T.
To install the toolkit, follow these steps:
Download the installation file from https://www.ni.com/en-us/support/downloads/software-products/download.ecu-measurement-and-calibration-toolkit.html.
Run the installation file and follow the instructions on the aa16f39245